MT6835 Magnetic Encoder Module 21-Bit for AS5048 A

MT6835 Magnetic Encoder Module 21-Bit for AS5048 A Description

The MT6835 chip is fourth-generation magnetic Angle encoder IC, an upgraded version of the MT6825, based on Anisotropic Magnetoresistive. The (abbreviated as ) technology and proprietary signal processing technology have achieved absolute Angle measurement from 0 to 360.
This chip consists of a pair of Wheatstone Bridges and a signal processing ASIC circuit. As the magnetic field parallel to the chip rotates, the chip can output Angle signals such as ABZ/UVW and PWM. Users can also read the 21-bit absolute Angle data inside the chip through the SPI interface that supports a clock as high as 16MHz.
Supports a maximum rotational speed of 120,000 revolutions per minute. The MT6835 chip can be applied to various scenarios with high-speed and high- control requirements, such as closed-loop stepper motor control, 2500-line servo, and 17-bit absolute value servo motor control, etc.

Based on technology, it provides absolute Angle measurement from 0 to 360
Operating voltage: 3.3-5.0V
Operating temperature: -40 to 125
Typical values of linearity deviation Less than 0.5 (factory value), typical values of linearity deviation Less than 0.07 (typical value self-calibration), typical values of linearity deviation Less than 0.02 (typical self-calibration)
The system delay is 2us to 10us, and it can support a maximum rotational speed of up to 120,000 revolutions per minute
It provides a standard 4-wire SPI interface (with a maximum clock of 16MHz) to read 21-bit Angle data inside the chip
The incremental output ABZ supports any resolution from 1 to 8192 lines
The incremental output UVW supports any pair from 1 to 16
It provides a 12-bit PWM output
Specifications: A: SPI+AB:8192
Color: Black
Material: PCB

Package Contents:
1 * Magnetic Encoder
1 * Magnet

Only the above package content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.