Rustins Polyurethane Floor Seal Gloss Finish 2.5 Litre

Rustins Polyurethane Floor Seal Gloss Finish 2.5 Litre Description

Rustins Polyurethane Floor Sealer Gloss Finish 2.5 Litre

Rustins Polyurethane Floor Sealer Gloss is a heavy bodied, pale coloured, solvent based polyurethane which gives a tough and durable finish. Resistant to water, alcohol, white spirit and similar solvents. Drying time is 4-6 hours. Can be applied to wood, cork, MDF and old concrete floors. Can be applied to already coated flooring without sanding as long as the surface is clean and free from wax.

Intended Use: Bare wood, hardboard, MDF, old concrete and unsealed cork. Interior floors only. See information sheet on Renovating and Refinishing Wooden Floors.
Type: A medium build air-drying alkyd polyurethane. The finish produced is tough, durable and resistant to oil, water and many chemicals.Special Features: Enhances the colour of bare wood when applied. Has a slight darkening effect on timber so test suitability before proceeding. May be applied over old existing floor coatings but test for compatibility first. Should not be applied over wax.

• Heavy bodied, pale coloured, solvent based polyurethane
• Gives a tough and durable finish.
• Resistant to water, alcohol, white spirit and similar solvents

Finish: Gloss

Size: 2.5 Litre

HOW TO USE:

Preparation The surface must be clean, smooth, dry and free from wax, dust and contaminants. Follow instructions on container. Our sheet on renovating floors contains further information. Nail holes and small cracks may be filled with Rustin's Wood Filler. Bare wood may be dyed before coating with Rustin's Wood Dye. Other brands of dye, stain or paints may be incompatible so a test should be carried out. Do not apply Rustins Knotting or Sanding Sealer. Although this product contains no colour, some timbers change colour significantly when coated, especially old sanded or reclaimed wood. Test first.

Application Apply evenly and liberally using a large brush or varnish roller. Finish application in the direction of the grain.
Coats 2 liberal coats are usually sufficient on wood. Cork and more absorbent surfaces will require 3 coats.

Drying Time Touch dry in approximately 2-4 hours, depending on the temperature and humidity.

Re-coating Time Re-coat when the previous coat is hard dry, typically within 6-8 hours depending on the temperature and humidity

Application Temp. Ideally 15-25ºC. Do not use below 10ºC or in conditions of high humidity. Coverage 13-15 sq.m per litre, 1 coat, depending on the absorbency of the surface.
Maintenance The coating will take about 24 hours to dry fully. During this period, it is recommended that the floor is not walked on. Afterwards, the surface may be kept clean by mopping with a mild detergent solution. To restore the gloss, use Rustin's Floor Shine. Worn areas may be recoated once cleaned and sanded, to provide a key. It is not necessary to re-coat the whole floor.
Compatibility The coating may be used over Rustin's Wood Filler and Wood Dye or wood bleached with Rustin's Wood Bleach. May also be used over Rustin's Polyurethane Varnish Stain.
Settlement STIR WELL BEFORE USE. Satin finishes may dry glossy if not stirred.
Clean-Up Use White Spirit or Rustins Brush Cleaner whilst still wet. If dried-on, clean equipment and brushes with Rustins Brush Restorer.