SG90 Servo Manual Control Board Single Channel Servo Trigger Module Serial Port Angle Speed Regulation Controller

SG90 Servo Manual Control Board Single Channel Servo Trigger Module Serial Port Angle Speed Regulation Controller Description

Operating voltage: 5V


Standby current: 10mA

Clearing the Code (Code Reset)
Press and hold the button the control board for 5 seconds; the LED will begin to flash. You may release the button once flashing starts, indicating the code has been successfully cleared.
Mode Setting

After successfully clearing the code, the number of times the button is pressed determines the operating mode. Upon the first press, the LED turns solid; if the button is not pressed again within 3 seconds of release, the mode is set based the number of clicks performed. Note: Do not make the intervals between clicks too short (a recommended interval is 0.5 to 2.5 seconds). Once the mode is confirmed, the light will flash a number of times corresponding to the number of clicks. The relationship between the number of clicks and the modes is listed below:

1 click: Self-locking mode
2 clicks: Interlocking mode
3 clicks: Momentary (Jog) mode
4 clicks: Reciprocating mode
5 clicks: Loop mode
Color: As Shown
Material: Plastic+Metal

Package Contents:
1*Servo Trigger Controller
2*cables